cam shaft washers - K model

Production K Models

Re: cam shaft washers - K model

Postby wz507 » Fri Apr 23, 2021 2:03 pm

Your KHK intake cams are also angle ground, albeit at a considerably smaller angle than the exhaust cams. Inspect the intake cams more carefully and you will see that they too are in fact angle ground. I just measured some KHK cams in a lathe with DRO and found the IN and EX lobes to be ground at angles of 1 deg and 3 deg respectively.
wz507
 
Posts: 279
Joined: Fri Dec 11, 2015 9:13 pm

Re: cam shaft washers - K model

Postby John R » Sat Apr 24, 2021 4:57 am

How about that! I'd never noticed the 1deg angle on K inlets, will check it out. I'm still learning, thanks!

The thrust will be to the outer end, but shim at the inner end will ensure the cam lobe doesn't rub the circlip when follower is off the cam with clearance at tappet. It's at that point in its rotation that the cam is passing over the circlip.
User avatar
John R
 
Posts: 68
Joined: Tue Apr 22, 2014 6:50 pm

Re: cam shaft washers - K model

Postby panic » Sat Apr 24, 2021 10:28 am

The inlet cam faces are not angled

The intake angle is different than the exhaust, but all K/KH/KR cam lobes are angled.
[url="http://victorylibrary.com/L-BK.htm"]The Linkert Book[/url]
User avatar
panic
 
Posts: 54
Joined: Mon Jul 29, 2019 5:33 pm

Previous

Return to K, KK, KH, KHK

Who is online

Users browsing this forum: No registered users and 6 guests