hd54kh wrote:Good morning all, I did some more digging and found the .250 far right rod. Looking in the parts book I was working on the premise of three rods. Now I have four??
You use 4 total pieces as the Spares book shows- the stepped left-most one in the clutch, 2 more 3/16" dia rods plus the 1/4" dia rod in the clutch worm release lever.
hd54kh wrote:As in the new picture I now have the four totaling 12.355, is there a total length standard that I should have or can I measure what I actually need?
Just assemble it as described above and see where the final 1/4" dia piece comes out in the worm release lever. There has to be adequate room to installer the adjuster in the worm release lever. That's all there is to it.