Page 1 of 1

Manifold Inlet Nipple Rivets

PostPosted: Wed Nov 10, 2021 11:17 pm
by JerrryR
Hi All, am I doing something wrong, the Colony manifold inlet nipple rivets seem to be to short for my KHK? They also appear to have a smaller diameter than what I have left of the original rivet.

Nipple Rivets.jpg
Nipple Rivets.jpg (239.61 KiB) Viewed 4020 times

Re: Manifold Inlet Nipple Rivets

PostPosted: Thu Nov 25, 2021 5:18 pm
by JerrryR
Hi All, just reaching out one more time looking for help with re-riveting a new manifold inlet nipple in a KHK cylinder. Have any of you done it? If so what did you use for nipples, the Colony ones seem to short and a little small on the OD.

Re: Manifold Inlet Nipple Rivets

PostPosted: Sat Nov 27, 2021 9:18 pm
by dr dick
if ya want to figure out what the rivet dimensions "should be" email me a sketch and ill make them for you in an assortment of lengths if need be.

Re: Manifold Inlet Nipple Rivets

PostPosted: Sat Nov 27, 2021 9:51 pm
by JerrryR
Thanks for the offer Doc.